How It Works

This slideshow requires JavaScript.

These plastic devices are designed to attach to a shirt of your choosing at any level. The sites on the back of shirt should be made lower by ½” to 1” this is to allow extra length when bending over.

Step 1:  Put pants at level that is comfortable and looks good. Pull shirt out of pants. Pull shirt down to overlap belt level.

Step 2: Place GesK support device chip at belt level. Hold your Gesk support device against shirt and turn shirt over. Keep chip against shirt.

Step 3: Feel prong on back of chip through shirt fabric.

Step 4:  Place ring at angle into circular groove then roll both sides of ring with thumbs along edges of prong. Make sure ring snaps into groove. Undo pants and belt, place shirt into pants making sure all plastic devices are below belt and waist of pants.  The bottom  of the belt should fit the “J” shaped hook. Keep belt tight so hook cannot slip up.  The PANTS are now secure. Remove the GesK device from the shirt by grasping the shirt at the point where it is  attached to the prong of the device. Grasp the device with your other hand. Twist your wrist. The device should pull apart from the ring readily.  DO NOT PLACE RING ON PRONG UNLESS THERE IS MATERIAL BETWEEN THE RING AND PRONG OR THE RING IS VERY HARD TO REMOVE.  If it is necessary to pry the ring off of the device, a teaspoon works well.

© GesK Pants Support | Site design by Augusta Free Press LLC